#Molex connector assembly instructions for free

The red wire must be on the side of the + sign printed on the module.Д¤. Heltec module (be careful not to push the socket on the module off the board with brute force - hold it Connect the cable with the small 1.25 mm JST connector to the connector on the underside of the Push button switch (otherwise the case might not fit very well). Make sure allД¬omponents are flush on the PCB - especially the rotary encoder, the trimmer and (I mentioned it) the Do not yet solder the 2 female pin headers, the cables and the loudspeaker. You will find all these components in the pink plastic bag (see also the picture at the end of thisДocument). The other - obviously - towards the loudspeaker.Дў. Protruding 'noses' on its case - one of them should be facing towards the long edge of the PCB, and Make sure it sits really flush on the PCB). Particularly careful with this one - it has a tendency to end up slightly slanted - it might not nicely fit the

Switch (the lever facing outward, of course) then the rotary encoder and the push-button switch (be See which one fits where) then the trimmer resistor )its orientation does not matter), and the sliding First solder the following components to the PCB: The 4 phone jacks (3 different types, but it is easy to Step-by-step instructions (at least read them, even if you decide to do itДЎ. Please notify if anyД¬omponents are missing or defective, so that some replacement can be sent to you! They will go, with the help of the placement drawing. Heat to make the joint, and staying there with the iron for many, many seconds waiting for the warm-upД¬heck that all components are ready - identify them with the help of the packing list, and identify where To make the joints quickly, and some of the parts are biggish if connected to ground, you need a lot of Soldering iron, set to a reasonable temperature (I prefer them to be a bit on the high side - allows you Soldering advice: Do NOT use lead-free solder (I mentioned it before, didn't I). Unless you want to make your life hard), good lighting, possibly a magnifying glass, a small wire cutterДЄnd (for assembling the case) a small hex key (2 mm if not available a T6X20 Torx will work Get all the tools necessary: a fine-tipped soldering iron, thin solder wire (do not use lead-free solder I am assuming that you are going to use a battery with a Molex connector - should you prefer aД«attery with a different connector, you need to supply our own cable with a fitting connctor for the Plate if it is VERY thick you could even combine the 6 mm and the 12 mm stand-offs to give youДЎ8 mm of clearance! If you do not need extra space below the PCB, use the 6 mm stand-offs. Sizes of stand-off bolts have been supplied - use the 12mm ones if your battery sits on the bottom Otherwise you should mount it to the bottom plate of the case, making sure you have enoughД¬learance between the battery and the PCB (Danger! Make sure no sharp ends of wires etc.ДЄre doing any harm to the LiPo battery - this could result in exploding batteries!).

If it is small enough it should fit under the Heltec module. Make sure you know which type of LiPo battery you are going to use, and where you are going to

#Molex connector assembly instructions for free

Happened - but you will understand that I cannot do so for free - I have to buy the parts myself.) Even kits that areД®asy to build can be ruined (of course I can supply you with spare parts should something bad have Strongly suggest that you get some help from someone who has that experience. While the kit is rather easy to assemble, you should have some kit-building experience. Morserino-32: Detailed Assembly Instructions